It's certainly not impossible to achieve a sunburst finish for your guitar if you follow a few simple tips and take great care. It's wise to practice initially with a scrap piece of lumber before replicating on your guitar.

If it's a totally new guitar kit,then build your guitar first. Of course you'll be pulling it down to apply the finish nevertheless, you should know that you won't befinding problems with the final build that endanger the finish which you have obviously put a lot of effort towards. Once you have assembled the electric guitar and checked for any problems you can begin to prepare the timber. Sand right back until finally you've got a very smooth base to apply your finish. At that point get rid off excess dust and clean the guitar extensively.

Following that apply a quantity of wood grain filler. You should put on heavily on the top belonging to the electric guitar after which you can work it in to the grain. As soon as it has dried remove and remove any excess filler with a moistened rag. Now it's time to paint the back and sides of the body and neck of your electric guitar. A significant point to keep in mind is to mask the face and neck. As you are spraying aerasol it's smart to keep the spray cans in quite warm water before putting in use. It is going to take a range of coats as a consequence you should not consider applying that much at one time. The secret is to increase your guitar colour layer upon layer and apply your colour from a reasonable distance away so that you achieve a feathered edge. The nearer you end up being the heavier the edge line you will end up with.

Next administer the amber lacquer. Chances are you'll be compelled to mask the sides of the guitar after which you'll put the guitar on your solid work bench face up before you apply. If you have finished this task you should apply the clear coat after that and sand between coats to remove any issues. Then carry out your next darkest stain to achieve a blend of coloration in between the edge and middle section gradations. Consider applying exceptionally lightly and amass the vital coats. About now it's essential to let the guitar dry out. Once the guitar is completely dry commence sanding for a second time.

This is the last part. The key here is to use a lighter gauge of sand paper each occasion before you are in reality removing the markings because of the gauge of sandpaper consumed preceding soon after which progressing to a finer gauge. Remember to keep gently sanding and then changing to a lighter gauge until you run out of sandpaper after which you can move on to your buffer.From this point you may should forever keep buffing or hand polishing until you get very happy with the finished look.